vRealize Automation – vCAC 6.1 – External Network Profiles
External Network profiles in vCAC enable you to create a range of IP addresses that can used to statically assign IP address to provisioned workloads in yo
networking
VMware NSX 6.1 for vSphere – Configuring OSPF route distribution
In my previous NSX articles we covered installing and configuring NSX , We discussed deploying/configuring Transport Zones , Logical Switches , Logical Rou
VMware NSX 6.1 for vSphere – Connecting logical and Edge Routers
This article builds on my previous article Deploying an Edger Gateway . In this article we are going to connect the Edge router we deployed in my previous
VMware NSX 6.1 for vSphere – Deploying an Edge Gateway
So far we have deployed (2) Logical Switches and (1) Distributed Logical Router and deployed a VM on to each logical switch . Our VM’s can communicate with
VMware NSX 6.1 for vSphere – Deploying Logical Distributed Routers
In this walk-through we will be deploying a logical router and configuring routing between (2) logical networks that we created in an earlier post. Logical
VMware NSX 6.1 for vSphere – Deploying Logical Switches
NSX Logical Switches can be looked at as the equivalent of a virtual VLAN. They identify the networks that you will be connecting your virtual machines to
VMware NSX 6.1 for vSphere – Setting up Transport Zones
If you are familiar with “Network Scopes” from vCNS then “Transport Zones” should be familiar to you. If not here is some useful information to know regard
VMware NSX 6.1 for vSphere Step-By-Step Installation
I know your excited to get right down to the meat of the installtion, but there is some housekeeping that we need to get out of the way first. There are a
DailyHypervisor Forums are online.
We have just launched our DailyHypervisor Forum located at http://www.dailyhypervisor.com/forum . Stop by, contribute and be a part of our community. The D
vCloud Automation Center: vCAC 5.1: Configure Static IP Address Support
vCAC has a feature that can be enabled to provide support for Static IP address assignments of provisioned workloads. This Static IP Address feature allows
A Different Take on CEE and FCoE
Last Month, I attended a Brocade Net.Ed Session that covered Converged Enhanced Ethernet (CEE) and Fibre Channel over Ethernet (FCoE) and the idea of Serve
Network configuration for automated ESX deployment
I have been asked this question a few times so I thought it would be wise to post an article on it. When deploying an automated build script with the kicks